High efficiency filter device control device

We usually use the new fan and the industry in the air exhaust equipment, etc., will be applied to the efficient filter. High efficiency filter is a widely used in industrial or household daily equipment, because the structure and function of high efficiency filter, so efficient filter widely acclaimed. The control devices in the high efficiency filter equipment play a very important role, so when the high efficiency filter equipment manufacturing needs to pay attention to the controller, the following deao technology to give you the introduction of high efficiency filter equipment control device manufacturing.

In the manufacture of control devices for high efficiency filter equipment, the main techniques used include all-welded construction, wall-mounted construction, local assembly and in-situ construction. All-welded construction refers to the completion of the control device of the high-efficiency filter device, which is mainly done by means of welding technology. In addition, it is possible to do some real-time preparation when the control device is started. It is for the support legs and its base In part. After the installation, the installation of high-efficiency filter equipment control device also need to import / export pipe, ladder, platform, railings and other accessories.

In general, when the control device of the high efficiency filter device is locally assembled, it is possible to move the control device to the workplace of the main body, including the inside of the high efficiency filter. The dimensions of the components of the high efficiency filter are, on the one hand, taking into account the convenience of transport and the other side requiring a reasonable distribution of the assembly process. For example, the assembly contact may be in the middle of the main body and the case, while the leg assembly and the main body part of the two steps alone action. This is the most common method of manufacturing the control device for air filter equipment. In order to save the cost of the workshop, the manufacturer should be in the workshop to complete some simple assembly, even if this is not because there are some size or overload problems and restrictions on manufacturing.